Sliding Patio Door Roller Adjustment

Adjusting the rollers on your pella sliding doors raises or lowers the door panel as necessary to get the door working.

Sliding patio door roller adjustment.

Over time the framing of your home settles. Also called sliding glass doors these doors are designed to glide horizontally with one operating panel and one stationary panel. In these cases the problem is usually that the rollers at the bottom of the door have started to rub against the track. How to fix a glass sliding patio door that dosnt roll close or lock properly.

Raise it just enough to clear the track and roll smoothly. Tinker around with the roller screws to see if the door glides better when it s at a lower or higher height. Turning this screw. The sliding panel should glide across the tracks when you open the door without jamming.

A sliding door will be out of alignment with the frame when the rollers need adjusting. This adjustment screw will move the roller height up or down and thus your sliding glass door height will go up or down by as much as 1 4 inch or 1 2 cm. You can alter the height of these rollers by accessing the adjustment screws which are set into slots on the door s outer edges perpendicular with the rollers themselves. Making the adjustments correctly will realign the door to reduce these problems.

Installed in each pella sliding door is a mechanism that moves the location of the lower track guide. The wheels on the glass sliding patio door have an adjustment screw at the bot. To start your sliding glass door adjustment project first lift or lower the door on the track with a screwdriver or allen wrench. Locate the adjustment screws on the lower edges of the door.

The lock will not meet up with the frame latch unless the rollers hold the door the correct height. Most sliding doors have a mechanism called an adjusting screw located at the bottom of the door ends. The patio door will meet the jamb at an offset angle if one roller is higher than the other. This causes the door to bind when moved or fall off the track or may cause the lock to stop working.

Locate the two adjusting screws at the bottom of the door on the face or edge of the door and pry off the trim caps that cover the screws. Overtime pella sliding doors fall out of adjustment. The rollers at the top can also wear down lowering the bottom of the door so that it rubs on the track. They fit into tighter spaces than our hinged doors because their panels don t interfere with your room or patio.